The manufacturer of Stamped Rigid Centralizer tells you that the centralizer product has undergone many changes from its birth to the present. Of course, we have also gained a lot from these changes, which is also an accumulation of experience. The manufacturer of Stamped Rigid Centralizer tells you that we still have to pay close attention to the birth speed of new centralizer products, because we have to catch up with market demand. However, we don't have to worry too much about this issue, because now the centralizer has applied two new application modes.

The Stamped Rigid Centralizer manufacturer tells you that these two types are thermoset and movable. The movable type is like this: two parts with the same shape and convex inner wall are connected together, and we can rely on the locking teeth to fasten. The thermosetting type is to inject the centralizer on the sucker rod body. The Stamped Rigid Centralizer manufacturer tells you that this can reduce the number of breakages of the sucker rod centralizer, and it is similar to the usual tubing break or perforation accidents, and the pump inspection cycle is prolonged. If Stamped Rigid Centralizer manufacturers use nylon material, the effect may be better.
The manufacturer of Stamped Rigid Centralizer tells you that when we need to have high requirements for its impact resistance and vibration resistance, we can also make improvements, because the sucker rod centralizer has reserved space for its upgrade at the early stage of its design.